360 Smart Bed Headboard Bracket Installation Guide

Applies to: 360 Smart FlexFit adjustable bases and Integrated Bases.

 

Before you begin

Verify the contents of the headboard bracket assembly kit:

A - (2) Headboard Mounting Brackets

B - (2) Headboard Mounting Tracks

C - (2) Headboard Mounting Flanges

D - (1) Headboard Bracket Mounting Kit

Headboard_Brackets.PNG

 

For 360 Integrated Base with Stylish Frame/Legs
  1. Mount (1) headboard mounting bracket (A) to base frame with (2) 1/4-20 x 1-1/2 hex head bolts and nuts. Tighten firmly. (Figure 1)
  2. Slide (1) headboard mounting track (B) into headboard mounting bracket (A) and attach using (2) 1/4-20 x 1/2 carriage bolts and nuts. Loosely tighten (for adjustment purposes.) (Figure 2)
  3. Mount (1) headboard mounting flange (C) to headboard mounting track (B) with (2) 3/8-16 x 3/4 carriage bolts and nuts. Loosely tighten (for adjustment purposes).
    HBFigure1.PNG
                                              Figure 1 - Attaching and assembly.
  4. Repeat the above steps to attach second assembly to the other side of the base.
  5. Adjust headboard mounting track (B) and headboard mounting flange (C) to line up with mounting points on headboard. Tighten bolts and nuts firmly. (Figure 2 and 3)
  6. Mount headboard (per instructions included with headboard) to complete procedure.
    HBFigure2.PNG
                                 Figure 2 - Mounting points on an Integrated Base.

    HBFigure3.PNG
                     Figure 3 - Slide bracket assemblies in or out to achieve position.
For 360 FlexFit smart base
  1. Mount (1) headboard mounting bracket (A) to base frame with (2) 1/4-20 x 1-1/2 hex head bolts and nuts. Tighten firmly. (Figure 1)
  2. Slide (1) headboard mounting track (B) into headboard mounting brackets (A) and attach using (2) 1/4-20 x 1/2 carriage bolts and nuts. Loosely tighten (for adjustment purposes).
  3. Mount (1) headboard mounting flange (C) to headboard mounting track (B) with (2) 3/8-16 x 3/4 carriage bolts and nuts. Loosely tighten (for adjustment purposes).
    HBFigure1.PNG
  4. Repeat the above steps to attach second assembly to the other side of the base.
  5. Adjust headboard mounting track (B) and headboard mounting flange (C) to line up with mounting points on headboard. Tighten bolts and nuts firmly.
  6. Mount headboard (per instructions included with headboard) to complete procedure.
    HBFigure4.PNG
                                   Figure 4 - Mounting points on FlexFit Base.
Was this article helpful?
29 out of 62 found this helpful